Is it possible to route Aux into the X-Live recording?

[G-Rad]

Okay, so I am officially confused. I can record directly from the local inputs, no problem, but that seems to be all I can record from. Even when I assign blocks of 8 in the recording section to User Input and assign 2 of them to Aux 1 and 2, the X-Live completely ignores this!

Here's my configuration.

/config/routing/in:
Local 1-8, Local 9-16, UI 17-24, A 9-16
UI 17-24: Aux1, AUX2, AUX3, AUX4, AUX5, AUX6, Off, Off

/config/routing/play:
Card 1-8, Card 9-16, Card 17-24, Card 25-32

When I run signal through aux 1 and 2, they do respond on channels 17 and 18 respectively.

When I record to x-live it will pick up anything in the 16 mics, but when I play anything through the aux, which is blocked to 17-22, it will not record these. or at least it will not pull from the input. IT records the channel, but the channel is blank.

Any help would be grateful. I only have 16 inputs and I use the aux to run samplers.

[pvannatto]

To send the same inputs to the X-Live, use the routing, card command.
/config/routing/CARD
and duplicate the assignments you made to the /config/routing/IN command

[G-Rad]

Thank you. This was successful. I do have a last couple of questions.

What is, if there is one, OSC command to change the sample and bit rate of recordings? I can not find those two pieces of information or at least maybe I over looked them, really easy to do when I'm blind. SO far though, this is working nicely. Implementing the X Live card.

[pvannatto]

The X-Live sample rate is set to 44.1K or 48K using the /-urec/srate command. The bit rate is fixed at (I believe) 24 bit.