Wing Accessories 3D Print files

[MJKlein]

If a bottom plate could be fabricated out of whatever, then the piece could be overlaid with the soft material and fabric on the top.

Let me get out my digital calipers and get back to you! Thanks Patrick.

[pvannatto]

Hey Paul at one point you were going to make some rj45 clip locks. Did you ever? Much needed for the IQ speaker and P16 systems. I keep threatening to buy a 3D printer...

Hey Gary, I didn't have to make an RJ45 lock - found one on Thingiverse, printed off a couple and tested one this morning. Works fine. If you can't find someone locally to print them for you, email me your address and I'll see what I can do. Here is the link
https://www.thingiverse.com/thing:1857420

Also if you are looking for a RJ45 lock fix (when the lock tab breaks off) here is one. It prints well without any support.
https://www.thingiverse.com/thing:4714711

[GaryH]

Thanks so much Paul, I may know someone around here with a printer now, friend of my son...

[henryjac54]

Amazing ideas! Thanks guys