DP48 AES50 return

[ldamkjar]

Thx a lot - I will load it and see if I can figure out how you did it and what you did I REALLY appreciate your help. These mixers can do SO much and so can you and this forum !!

[ldamkjar]

Hi again Paul

By The Way - What does it mean that output 4 was “inverted”?

[pvannatto]

What does it mean that output 4 was “inverted”?

If you look at the Routing, Out 1-16 screen, the second column is the phase and for output 4 it is inverted (polarity reversed).

[nzifra]

Might be a dumb question, but do multiple DP48's cascade returns? So DP48 1 is AES 1-8, DP48 2 is 9-16, etc?

[pvannatto]

Might be a dumb question, but do multiple DP48's cascade returns? So DP48 1 is AES 1-8, DP48 2 is 9-16, etc?

Welcome to the forum. Yes that is correct. That means that you can have up to 6 DP48 cascaded on each AES50.

[nzifra]

Thank you! So that means if I'm running AES A to DL 32, and AES B to DP48's, I could use the User defined routing to route the DP48 outputs to the outputs of the DL32 for wireless IEMs?

[pvannatto]

You wouldn't necessarily need to use the User screen. Just assign the appropriate AES50 B inputs to the AES50 A outputs.

Of course if you had a Hub4, you wouldn't need to have to redirect DP48 outputs (via AES50 B to A), if you mounted the wireless IEM transmitters in the same rack as the Hub4 and connected from the back of the Hub4 to the transmitters.