Page 1 of 1
Parametric EQ bug or by design ?
Posted: Tue May 31, 2022 5:52 am
by buzzkill
when you change the settings from FULL Parametric OFF to ON the display changes , it really should stay ON IMO ? maybe a bug ?
Full OFF
FULL ON
Re: Parametric EQ bug or by design ?
Posted: Tue May 31, 2022 8:57 am
by kgallen
I agree with you but maybe they removed the fill because the picture would not give a good representation of the frequency response once you start adjusting the frequency nodes. Hopefully they will improve this in a later firmware.
Re: Parametric EQ bug or by design ?
Posted: Tue Sep 27, 2022 8:41 pm
by therentabrain
I love the Flow8 and it has become a wonderful tool for mixing on the go.
But yes, this was so confusing to me. Especially because "width" gets narrower the higher the number. I had no idea that was the case, and I couldn't figure out why the parametric wasn't doing anything good.
If I had seen a display like on every other digital EQ I have used, that would have been incredibly useful!
In a related story: Do we know what the "Full Range" button does? I heard no difference.
Re: Parametric EQ bug or by design ?
Posted: Wed Sep 28, 2022 9:50 pm
by buzzkill
therentabrain wrote: ↑Tue Sep 27, 2022 8:41 pm
I love the Flow8 and it has become a wonderful tool for mixing on the go.
But yes, this was so confusing to me. Especially because "width" gets narrower the higher the number. I had no idea that was the case, and I couldn't figure out why the parametric wasn't doing anything good.
If I had seen a display like on every other digital EQ I have used, that would have been incredibly useful!
In a related story: Do we know what the "Full Range" button does? I heard no difference.
Full range gives you Freq. and Range or Q control ( width of freq range ) like a more expensive unit.
Re: Parametric EQ bug or by design ?
Posted: Thu Sep 29, 2022 11:00 am
by therentabrain
buzzkill wrote: ↑Wed Sep 28, 2022 9:50 pm
Full range gives you Freq. and Range or Q control ( width of freq range ) like a more expensive unit.
I'm referring to the FULL RANGE button at the top right. I'm staying in parametric mode. I tap Full Range and it lights up, or turns off, but I don't see or hear anything different.
Or maybe I didn't understand what you were saying
Re: Parametric EQ bug or by design ?
Posted: Thu Sep 29, 2022 11:05 am
by Peter Z
Full range sets the frequency range on each band to 20-20000Hz. „Non-Full“ range sets it to a limited bandwidth according to the selected band. This allows finer adjustments.
Re: Parametric EQ bug or by design ?
Posted: Thu Oct 06, 2022 4:13 am
by therentabrain
Oh I didn't notice that! Makes sense. I wish there were a really friendly and complete manual.